Product Data Sheet ar   63

AR63


600W 120V AC, 60 Hz, Three way - push on/off. Incandescent Control

Hubbell Wiring Device-Kellems Product Specifications
 Type  Dimmers
 Actuator Type  Rotary
 Switch Type for Dimmer  Three Way
 Grade  Architectural
 Wattage  600 Watts
 Voltage  120V AC
 Termination Type for Dimmer  Wire Leads
 Color  
 Enhancement  Push On Push Off
 Approvals  UL listed

Ganging Charts
Switchboxes Required: Side Sections Intact
Number of Small Controls (600W & 1000W)
0 1 2 3 4 5 6
Number of
Large Controls
(1500W & 2000W)
0
1
2
3
4
0 1 1+1 4 1+4 7 1+7
1 3 5 6 8 9 11
4 6 7 9 10 12 13
6 8 10 11 13 14 16
9 11 12 14 15 17 18

Note: When ganging an even number of small controls with no side sections removed (plus numbers in chart), use gangable switchboxes with tapped ears as shown below. Do not use plaster rings or gangbox covers. Space an additional switchbox ¾" apart from the other switchbox(es). A ¾" close nipple is recommended as a spacer between the switchboxes.




Switchboxes Required: Side Sections Removed
Number of Small Controls (600W & 1000W)
0 1 2 3 4 5 6
Number of
Large Controls
(1500W & 2000W)
0
1
2
3
4
0 1 2 3 4 5 6
1 3 4 5 6 7 8
3 5 6 7 8 9 10
5 7 8 9 10 11 12
7 9 10 11 12 13 14

Note: When removing side sections, remove only inner side sections. Do not remove side sections on outer ends of gang.
Same installation rules apply to rotary dimmers (not shown).




Derating Chart
No side
sections removed		 One side
section removed		 Both side
sections removed
600W 600W 500W
1000W 900W 700W
1500W 1250W 1000W
2000W 1800W 1500W
6A fan speed 4.2A 4.2A

When ganging any combination of small and large controls, place a small control on one extreme end of the gang, and a large control at the other end of the gang. When ganging with side sections intact, use offset mounting holes. When ganging with side sections removed, use center mounting holes. Allow a 1/32" gap (space) between controls for ease in attaching the faceplate.



 

Hubbell Wiring Device-Kellems